Friedrich MR09C1H Manuel d'utilisateur télécharger pdf (Page 11)

Pressing CLOCK button,

blinks. Within 5 seconds , pressing + or - button adjusts the

present time. Holding down either button above 2 seconds increases or decreases the

CLOCK :

time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During

blinking after setting, press CLOCK button again to confirm the setting, and then

will

be constantly displayed.

Remote Controller Description

This button is used for setting Fan Speed in the sequence that goes from AUTO,

then back to Auto.

FAN

MODE :

Each time you press this button, a mode is selected in a sequence that goes from AUTO,

COOL,DRY, FAN,and HEAT

,as the following:

AUTO

COOL

DRY

FAN HEAT

*Note: Only for models with heating

function.

After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not

be displayed on the LCD, and the unit will automatically select the suitable operation

mode in accordance with the room temperature to make indoor room comfortable.

Press this button to turn on the unit .Press this button again to turn off the unit.

Press this button to decrease set temperature. Hold it down for above 2 seconds to

rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable.

Press this button to increase set temperature. Hold it down for above 2 seconds to

rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.

Auto

Low speed

Medium speed

High speed

Remote Control Instructions

SENSOR

according to the sensed temperature. Press this button again to cancel function.

START / STOP

AUTO

Press this button to turn on function. The unit automatically adjust temperature

SENSOR

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Friedrich MR09C1H Manuel d'utilisateur Page 11