Friedrich WE12D33 Manuel d'installation télécharger pdf

INSTALLATION INSTRUCTIONS

SUBBASE FOR WS, WE & WY MODELS

These instructions are provided for installation of the WallMaster Subbase. This accessory subbase can be used

whenever a WallMaster air conditioner is installed in a wall from 2" to 12" thick, or when additional support or leveling

of the unit is desired.

NOTE: The subbase should be assembled to the WSC sleeve before sleeve is installed in the wall, however it may

be used with existing installations.

ELECTRICAL DATA

STEP 1. A ﬁ eld supplied receptacle to match chassis plug may be installed for power cord connections. Also, a

location for an optional ﬁ eld-supplied disconnect switch is available.

STEP 2. Refer to chassis nameplate for proper circuit requirements.

STEP 3. All wiring must comply with local and national electrical codes.

INSTALLATION INSTRUCTIONS

STEP 1. Attach left and right side template to WSC sleeve as indicated. Drill two 9/64" diameter

holes in both sides. Remove templates.

STEP 2. Attach mounting brackets to sides of subbase and ﬁ ller plate with four 3/8" phillips screws as

shown in Figure 1. Do not tighten.

FIGURE 1

617-407-00 (10-04)

1 2

INSTALLATION INSTRUCTIONSSUBBASE FOR WS, WE & WY MODELSThese instructions are provided for installation of the WallMaster Subbase. This accessory

Page 2

STEP 3. Attach subbase mounting brackets to holes in sleeve from Step 1 with four 1/4" phillips screws.STEP 4. Determine correct distance from

Plus de documents pour Non Friedrich WE12D33

Friedrich WE12D33 Garantie (1 pages)

Pas de commentaire